Zlib Compression

Mors · October 5th, 2006, 03:27 PM

I wanted to make sure I did it correctly. are you using a 1 = yes and 0 = no format or do I need to type in Yes / No to enable Zlib compression. Also is there a way to know if it is being used properly.

Chuck S · October 5th, 2006, 03:46 PM

zlib compression is set in Admin => Global Options

You might need to do a search on the web there are some sites that check this

Mors · October 5th, 2006, 03:51 PM

yes was looking for your setting to enable the use of it. right now it shows 0 and I wanted to turn it on under global settings.

Chuck S · October 5th, 2006, 03:51 PM

It should not say 0 unless you maybe overwrote your config file before upgrade

place yes in there

Mors · October 5th, 2006, 04:04 PM

Thanks .. it was kind of confusing. Usually when you see 0 it means the boulean NO and 1 would be YES etc. Just wanted to verify that

This was a first time "fresh" installation. There are a lot of sections that have a 0 next to them. What should these have ?

Chuck S · October 5th, 2006, 04:15 PM

http://www.gidnetwork.com/tools/gzip-test.php