Member Gallery Pagination Link constructed wrong

cellarius · September 26th, 2010, 07:23 AM

If I go to my member gallery and want to navigate to another page within it, the link in the pagination is constructed like that:

Code:

Content visible to verified customers only.

The part in red is not needed; in fact, it breaks pagination since it makes the link not go to page 3 in my member gallery, but to page 3 in the category with the id 2.

The links are constructed with this -cat2 part (as far as I can see) for all my members, and I can see them using my admin account and a test account with normal user permissions.

I just tested this at your place, Chuck:
- ReefTalk Gallery

There should be 199 images in this gallery, and 5 pages are listed in pagination. If I try to go to page 2, the link is:

Code:

Content visible to verified customers only.

This obviously will not work. The link leads to page 2 in a category with id 504, and it shows in this case an empty gallery page.

See screenshots.

cellarius · September 26th, 2010, 08:12 AM

To solve the problem, on my site, in file pp-inc.php I commented out the lines (around line 2315 in the file)

Code:

Content visible to verified customers only.

and replaced the elseif with an if in the following line.

I did not experience any disfunctions by this change up to now, but asked my members to report any irregularities. If any should surface, I'll pass them on.

Chuck S · September 26th, 2010, 09:55 AM

I think I will need to think on this issue because the whole issue is if you remove that ability to specify a cat then any category you set as a members gallery will not work so I will have to think on how to make it work for all.

Chuck S · September 26th, 2010, 06:59 PM

You want to use the default files and maybe edit showgallery.php like this

You will see the init variables line at top of showgallery.php.

Make that line this instead

Code:

Content visible to verified customers only.

cellarius · September 27th, 2010, 01:20 AM

That works, thank you. I gather a fix for this will make it into the next release?

Chuck S · September 27th, 2010, 08:11 AM

Yep already applied to the source code when I release 7.03 shortly it will be in there.

cellarius · September 27th, 2010, 08:20 AM

Great!

Chuck S · September 27th, 2010, 09:34 AM

No problem enjoy your day