View Full Version : How to change this?
February 7th, 2009, 01:04 PM
The images shows next to eachother pushes the entire site. How do I change this?
This error shows up when uploading:
February 7th, 2009, 04:16 PM
I cant read any of your photos as they are links to a site that is down at the moment.
If your talking about next image previes etc you can turn off the next prev image display under admin showphoto options.
As far as any other error you would need to tell me what the actual error is since I cant read that image.
February 8th, 2009, 06:54 AM
Perhaps this helps:
February 8th, 2009, 07:57 AM
Under Admin, Show Photo Options, you can set the default location of photo previews to left or right (shown vertically, rather than horizontally) which will probably resolve your problem.
February 8th, 2009, 10:47 AM
Yes as digifusion points out also. You can turn them off as I note or you can move them to display top bottom right or left.
As far as your second issue your photos as noted are way too small. Just tell me what the error is so I can assist you. ;)
February 9th, 2009, 07:00 AM
How do you expect me to tell what the error is if it cant be viewed on a screenprint and it wont allow me to copy it when showing on the upload directly?
Can I get you to go to the board and test yourself? Either if I create a test account for you or you can make one yourself.
February 9th, 2009, 07:05 AM
Perhaps this works better for you:
February 9th, 2009, 10:41 AM
You could tell us what the error is if you do not post links and logins to your site.
I have good vision but not good enough to read a blurry error on a 150x120 pixel thumb posted here. ;)
exec has been disabled on your server by your host. That means you can not use Imagemagick, jpegtran or jhead. You can under global options in admin make sure you clear the lines for jpegtran and jhead and use gd2 as your image processor and you will be fine.
February 10th, 2009, 02:08 AM
...and you will be fine.
The uploads works just fine and has the entire time. But the error still shows. Also after clearing the lines for jpegtran and jhead and using gd2 as our image processor.
February 10th, 2009, 09:50 AM
Exec is only called when using Imagemagick, Jpegtran or Jhead
You can sent an admin login and url to us via the contact link in the header above.
vBulletin® v3.8.1, Copyright ©2000-2014, Jelsoft Enterprises Ltd.